Soiltechnics laboratory is equipped with equipment to perform all types of geotechnical testing that is required in any site investigation project from basic to advanced test. BS 1377 : MS 1056 : ASTM : ISRM : APHA : BS EN ISO Description / Test 1.0 Classification Test 8.0 Direct Shear Test (Shearbox) 1.1 Moisture Content 8.1 Consolidated Drained Shear 1.2 Bulk Density 8.2 Multireversal Shear 1.3 Specific Gravity   1.4 Atterberg Limit-1 Point 9.0 Permeability 1.5 Linear Shrinkage 9.1 Constant Permeability Test in Triaxial cell 1.6 Coarse Grained Analysis-Sieving 9.2 Constant Permeability Test in Permeable cell 1.7 Fine Grained Analysis-Hydrometer 9.3 Falling Head Permeability     2.0 Chemical Test 10.0 Consolidation/Settlement 2.1 pH Value 10.1 One- Dimensional Consolidation Test 2.2 Sulphate Content 10.2 Collapse Potential 2.3 Organic Content 10.3 Swelling pressure measurement of swelling 2.4 Chloride Content 10.4 Shrink Swell Test 2.5 Sulphite content   2.6 Total Dissolved Solids 11.0 Compaction 2.7 Total Suspended Solids 11.1 Compaction Test 2.8 Salinity Test 11.2 Vibrating Hammer 2.9 Loss on Ignition 11.3 California Bearing Ratio Test(C.B.R.)     3.0 Unconfined Compression Test (UCT) 14.0 Rock 4.0 Triaxial-Unconsolidated Undrained (UU) 14.1 Compressive Strength of Rock 5.0 Triaxial-Consolidated Undrained (CIU) 14.2 Point Load Test 6.0 Triaxial-Consolidated Drained (CID) 14.3 Young’s Modulus & Poisson’s Ratio 7.0 Triaxial-Consolidated Drained (CID)     read more